Xecuter LT Switch v1.5 NEW VERSION
Product Description
This is the new Xecuter LT Switch v1.5 – the latest version in the #1 selling Xecuter LT Switch range.
Xecuter has designed a simple switch for all the Liteon drives that enables firmware full read/write. They have also included an ON/OFF Led to show correct operation when switching to 0x72 vendor mode.
Now Includes MULTI-R Function. After the discovery that a small number of Liteon drives would not dump the fw with a 20 ohm resistor – but required an 18 Ohm or 22 Ohm resistor – so you can now select between 18, 20 and 22 Ohms ! (Default should be set to 20 Ohms – this will work 99% of the time)
The installation is very simple and takes about 5 minutes if you have some small experience with a soldering iron. It has been tested with the latest Jungle Flasher 0.1.73. All Liteon drive versions have been tested with 100% Success (Including the troublesome Winbond IC). There is no need to remove the LT Switch after it has been installed – simply switch to normal mode and you are good to go. Even if you have to upgrade in the future – you don’t have to touch the switch again !
Don’t be fooled by more expensive copycat products. This is the only solution you need to do a very simple job. Remember this product follows the K.I.S.S engineering principle (KEEP IT SIMPLE STUPID) :
- The Only Liteon Solution Recommended By Team Jungle
- Enables Read/Write on ALL Liteon 74850, 83850, 93450 DVD Drives
- Easy & Simple Install – Install Once & Forget
- Enable / Disable Switch
- Multi-R Switch (18, 20, 22 Ohms)
- On/Off LED
- Completely Undetectable
- No Need To Uninstall
- Works with ALL tools including the latest Jungle Flasher
Package Content
- 1 x Xecuter LT Switch v1.5
